Maintenance & Technical > KX100 / KX85 / KX80 / KX65 / KX60

clutch basket removal

<< < (7/7)

gwcrim:
IT' OFF!!!

I put the hub holder on tight, applied generous amounts of heat via a map gas torch and then whacked it with my impact gun.

Of course, the hub got hot and the holder squeezed it way out of round.  In hindsight, I should have known better than to squeeze it so tightly but I was so intent on getting it off that all caution was through out.

Bike Bandit lists them at $37.  GRRRRRRRRR!!!!!!

Team 51:
Newbie here...I am currently having a heck of a time trying to get the bolt off my sons 2004 KX65. Can you confirm that the bolt thread is not reversed? Thanks

Team 51:
Finally, it is off!!! No, it is not reversed thread to answer my own question. A ton of heat and about 110 psi on the impact wrench finally broke it loose. Great thread!!! Thanks kxriders.

I am in the process of splitting my first case to replace the lower bearing rod so I am sure I will have more questions going forward.

Navigation

[0] Message Index

[*] Previous page