General > In General...

measurements ......

<< < (3/3)

Danger4u2:
Keep us posted with pictures, I would like to see the outcome. Good luck.
Danger

metallicarebal:
Well, I checked the frame with the measurements and it looks like I'll be using a pair of K5 rads too.

The red line is where the fork in the frame has to come to for clearance of the pipe, as you can see the stock RMZ rads are just way too humungous, so I think I'm just gonna get a whole bike to take anything I need off of and then part the rest out. I'll have to get K5 rads and weld mounts onto the frame for them before I can go any further ....... So I guess I'll just put the whole thing on hold untill I get all the parts I need and then go at it. Thanx for all the help guys. I'll start a new thread when I get myself a K5 parts bike.

Arigato:
What if you used a ZipTy pipe?  Pro-Circuit made pipes for the Rocket Racing kit a few years ago, it was also a low-boy design.......Just throwin' stuff out there.  Good luck.

metallicarebal:
No see, I need different rads regardless of the pipe I use. The pipe won't make it through the frame unless I bring that fork up higher so theres more length of frame consisting of two tubes instead of one. I'm not worried about the pipe clearing the rads, I'm worried about the frame clearing the rads when I raise that fork so that the pipe can come between those two tubes. I do plan on using the zipty pipe on it once i get that far though. Thanx for the input.

Navigation

[0] Message Index

[*] Previous page