Commercially available service offered by members of KXRiders. > OEM-CYCLE

KX500 real dyno numbers at KX Guru Racing

<< < (2/3) > >>

sandblaster:

--- Quote from: mlstoner660 on September 07, 2020, 09:09:08 PM ---Just found this thread that's some awesome info thanks. I wonder how an npp or a growler pipe would do compared to the mass produced pipes? I'm thinking of ordering the growler just not sure if it would be worth changing to it over my pc2.

--- End quote ---

I have a Growler pipe.
it performs on par with a PC2 pipe.
The PC1 or the FMF Desert Gnarly are making more power.

sandblaster:

--- Quote from: KXDINO on September 08, 2020, 09:32:11 AM ---98 octane i use , i can see the differance between useing both oils , i use to use the motul 800 and still useing the same fuel when useing  motorex and it cleaner, and a lot easier to clean the parts as well, i only tried motorex because vhm people said motul 800 was dirty and i notice it in a lot of 2t powervalves that it harder to clean off. vhm guys were right on the money.

--- End quote ---

Good to know.

mlstoner660:
Thanks for the info concerning the growler Sandblaster. Looks like I need to go a different route seeing how it cost quite a bit more and performs similar to what I have. Trying to find something for my street 500 that will move the power higher in the rpm range and bump it up some.

sandblaster:
The PC1 or the FMF Desert Gnarly

motorman455:
It's also surprising to see how well the Rad Valve does. I've always assumed it was more of a low end improvement but seems to be helping peak power.

Navigation

[0] Message Index

[#] Next page

[*] Previous page