Commercially available service offered by members of KXRiders. > OEM-CYCLE
2016 Pumpkin seed build...
Foxx4Beaver:
--- Quote from: sandblaster on September 17, 2019, 05:47:24 AM ---Shipped! 8-)
--- End quote ---
Speedy delivery! :mrgreen:
sandblaster:
A little more progress
sandblaster:
It's been a long long build. Many hours of engine R&D, polishing, fabrication, starting over, frustration, happiness, and now excitement. We are very close to the build off. I wish I could post pics but all I can show is this small teaser..
sandblaster:
Jason Tanner and I were doing some testing and tuning of the KtX500e.. Jason rolls out of the driveway in 2nd gear. Then he blips the throttle just a touch... Then he flogs it with no clutch work out of the hole. He goes through the gears, turns around and comes back only to tell me that the clutch was slipping. 😲 I had just rode it and I weigh about 70 more lb than Jason so I knew the clutch was fine. We walked out to the street and looked,,, Jason left a black strip for 165 yds down the street... Yes, the bike will be getting new knobs for the build off. And, we de-tuned the engine just a smidge 😃 https://www.youtube.com/watch?v=cmKjp4qYMQ4
Kawafornication:
Sounds sweet, did JT offer to replace the clutch?? where there is a blame there is a claim :-D
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version