Commercially available service offered by members of KXRiders. > OEM-CYCLE
2016 Pumpkin seed build...
DoldGuy:
Are they small or large axle forks?
sandblaster:
I haven't measured them but I believe they are 20mm..
It's definitely not the 26mm..
sandblaster:
I finally got the KTM muffler pulled completely apart...
In case you don't know, I'm coring it for a KX500
motorman455:
That's funny. I just got the Ti Powercore 2.1 yesterday and am doing the same thing! I removed both brackets and am going to rivet just the rear one back on in the proper location and put rivets back into the original holes. It has a 30mm inlet pipe vs the 32mm on the k5 (28 and 30mm id's respectively). I cut the inlet pipe off 1" from the silencer and have a straight section of 32mm od pipe from my scalvini pipe which slips right over the silencer inlet. The people at FMF were totally useless and wouldn't bother to even give me the dimsions of the few that they carry for modern 2 strokes so it was trial and error to find one close. I tried the YZ250 one first but it was only a 28mm inlet pipe.
WRXBRUMBY:
Moving forward. 8-)
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version