Maintenance & Technical > KX250 / KX125

1985 kx250, clutch problems

<< < (3/3)

bearlsoh:
I also have a 1985 kx250 clutch not working i can pull the handle and it acts like handle isnt pulled in iv pulled clutch cover found inner hub broke replaced inner hub and still not working any ideas on what im miss also torqued everyrhing to spec spring bolts 78 in pds...
 Any help is much appreciated

umberto:
Hi bearlsoh, welcome to the site.  I would go to a site like Rocky Mountain ATVMC and head over to the OEM parts section.  They have parts fiches for all the bike.  I would start by making sure that all the parts you need are present.  I would then look at the clutch rod to make sure it's not worn out, and that the clutch arm is still solidly welded and not spinning. If you push on the clutch arm, is it hard to push, or can you move it easily?  Is the clutch cable in good shape and does it move the clutch arm when you grab the clutch lever?  Were you riding when it broke, or was the bike sitting for a long time?

reklessj:

--- Quote from: umberto on December 12, 2018, 08:18:18 AM ---Hi bearlsoh, welcome to the site.  I would go to a site like Rocky Mountain ATVMC and head over to the OEM parts section.  They have parts fiches for all the bike.  I would start by making sure that all the parts you need are present.  I would then look at the clutch rod to make sure it's not worn out, and that the clutch arm is still solidly welded and not spinning. If you push on the clutch arm, is it hard to push, or can you move it easily?  Is the clutch cable in good shape and does it move the clutch arm when you grab the clutch lever?  Were you riding when it broke, or was the bike sitting for a long time?

--- End quote ---
I couldn't find parts I needed on Rocky mountain (first time ever I love Rocky Mountain) I found this place had everything I need, my bikes not that old though
http://www.2wheelpros.com/

Navigation

[0] Message Index

[*] Previous page