Maintenance & Technical > KX250 / KX125
Craigslist Find Project
umberto:
The reason I swapped out the wheels is because the other ones had been painted with what appeared to be an undercoating paint. :-o
umberto:
I got the motor apart today, and was sailing along when I caught this out of the corner of my eye. It's a small crack on the clutch side case. It goes through to the other side. Should I replace this case just to be safe, or is this not serious enough to warrant a replacement? Everything else is in excellent condition.
umberto:
Could I have the crack welded on the back side, or use an epoxy to hold it together?
sandblaster:
I hate epoxy on cases.... But that's probably because I run into it so often.
I would V out the crack, tig weld it, then resurface the mating surface.
No worries after that..
umberto:
Thank you for the reply Sandblaster! I'll get it welded up and move forward.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version