Maintenance & Technical > KX500 Steel Frame Conversion (SFC)
07 KTM 250sxf/500kx conversion
dave916:
What kind of gasket carb sealer does everbody use to hold oring in position for fitting?
hunter:
Will definitely look into the metering block oring. Thanks for the heads up on that one.
hunter:
--- Quote from: dave916 on June 17, 2019, 01:33:03 AM ---jetting i would be starting AROUND 1368n needle 52piloT 170main
Check the metreing block oing before you start {youtube it}
--- End quote ---
Keep the #6 slide as well?
dave916:
--- Quote from: hunter on June 17, 2019, 01:11:17 PM ---
--- Quote from: dave916 on June 17, 2019, 01:33:03 AM ---jetting i would be starting AROUND 1368n needle 52piloT 170main
Check the metreing block oing before you start {youtube it}
--- End quote ---
Keep the #6 slide as well?
--- End quote ---
never noticed much differance with slides / 6 or 7 fine
hunter:
Update:
1. Head came back from Larry. Its so d**n nice I almost didn't install it. It also makes everything else look like crap lol. Thanks Larry!
2. Good call on the Meteringblock oring. I barely touched it and it broke apart. New o-ring and 1368n needle clip on center with 168/52 installed. Couldn't find a 170 local to me.
3. Got the Top end done, motor is in bike. Need to order some new rubber mounts for the radiators.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version