General > In General...
Sean Colliers New KX500
ecdeyzel:
--- Quote from: Foxx4Beaver on August 14, 2016, 10:56:04 AM ---
--- Quote from: sandblaster on August 14, 2016, 03:28:30 AM ---Yep... It's a bit haggard
--- End quote ---
that's not bad at all....I don't remember if it's on this site, or another one, someone had a pic of the same spot, sawed right through to the sleeve....big ole hole! :lol:
--- End quote ---
Think it might be mine you where thinking of there Fox :-P
I wasn't too happy when I saw that, but patched her up.
Ed
Foxx4Beaver:
--- Quote from: ecdeyzel on September 26, 2016, 12:40:53 AM ---Think it might be mine you where thinking of there Fox :-P
I wasn't too happy when I saw that, but patched her up.
Ed
--- End quote ---
haha!....yeah it could've been yours Ed...that looks familiar. :wink:
sandblaster:
Push to bearings out... Clean it up.... Put a cleaned up old bearing or just the outer sleeve back in there and tig weld the aluminum up.
Press the old bearing or sleeve out...
Now your ready for new bearings and seals... 8-)
sandblaster:
Foxx4Beaver:
that's gonna look "trick". :mrgreen:
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version