General > In General...
Sean Colliers New KX500
Foxx4Beaver:
--- Quote from: sandblaster on August 14, 2016, 03:28:30 AM ---Yep... It's a bit haggard
--- End quote ---
that's not bad at all....I don't remember if it's on this site, or another one, someone had a pic of the same spot, sawed right through to the sleeve....big ole hole! :lol:
Pmcg:
--- Quote from: sandblaster on August 14, 2016, 03:28:30 AM ---Yep... It's a bit haggard but a little welding, sanding, filling, more sanding, primer, paint, decals, bearings, and seals, will have it looking great again.
--- End quote ---
I didn't even notice that. Sorry.
sandblaster:
--- Quote from: Pmcg on August 14, 2016, 11:15:18 AM ---I didn't even notice that. Sorry.
--- End quote ---
Are you kidding? This was perfect for our needs.
Everything you see will come out looking marvelous...
And thank you again for donating it.
sandblaster:
I made a bit more progress today.
Machined the slots out to 25mm and assembled with a complete KX450F rear wheel, axle, spacers, ect..
Now I need to make the hanger for the brake mount..
umberto:
Are you doing the dual piston caliper?
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version