Commercially available service offered by members of KXRiders. > OEM-CYCLE

JT Engine works 2001 RM250 bike build

<< < (2/3) > >>

sandblaster:
Every bearing, washer, seal, bushing, o-ring, seal, gasket, spring, ect ect has been replaced in the engine and chassis...
Even though it's not a Kawi I think the customer is going to be very happy.
Unless he want's to ride it in the sand...I hate the way these RM's of this chassis series turn in the sand...
Then again when compared to a K5 in the sand it's like comparing a turd to a diamond  :lol:

mikectanker:
Any pics of the finished bike?

sandblaster:
He just did the second heat cycle tonight.
I'll see if I can get some pics tomorrow.
It looks pretty good but he is waiting for the tank graphics to come in due to the tank looking so bad..

sandblaster:
The customer is coming to pick the bike up tonight so I guess I better post a update...
Done...  :-D
Four heat cycles done... I guess that will be good enough..
The customer will have to finish the break in..

mikectanker:
Looks way better than the new one I bought in 2001

Navigation

[0] Message Index

[#] Next page

[*] Previous page