Maintenance & Technical > KX500 Aluminum Frame Conversion (AFC)
2014 KX 250F/KX500 AFC
alexander-vmann:
tkeen511:
Gotta love when more parts show up right? :mrgreen:
mikectanker:
Any progress on the build?
tkeen511:
Yeah but not as much as I'd like. I'll post some pics soon
pre-mixed:
--- Quote from: tkeen511 on January 17, 2016, 03:13:39 PM ---Well I have very slowly been making some progress on the build. Been taking the engine apart on the 2 stroke motor, planning on sending it to sand blaster for some vapor blasting. Also thanks to jbernard I got some sweet frame rails and yoke, so far it looks like everything will fit pretty nicely. I got some cutting done today but it's about -8 F here right now, so I was working in the basement and the compressor didn't have enough juice to power the air tools to cut out the welds, so I'm gonna wait till it warms up a little to work in the garage and get these welds cut out and start doing some tacking.
--- End quote ---
where did you get those good looking frame rails and Y? I am looking at a 2013 KX250f and thinking about putting a 14 KTM 300 motor in it...
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version