Maintenance & Technical > KX100 / KX85 / KX80 / KX65 / KX60

90' kx80 bottom end rebuild

<< < (2/2)

Polloloko80:
To press the cases together i used the tusk crank puller and installer and that got my cases nicely together with not much effort. It was a great experience using these tools that ive never seen and then seeing how they work and actually get everything nicely fitted.

dave916:

--- Quote from: Polloloko80 on September 25, 2015, 09:05:59 AM ---To press the cases together i used the tusk crank puller and installer and that got my cases nicely together with not much effort. It was a great experience using these tools that ive never seen and then seeing how they work and actually get everything nicely fitted.

--- End quote ---

You should use a crank jig to stop the crank webs pressing together {would untrue the crank doing it like that}
If cases went nicely together with not much effort you probably got away with it
 Good luck with build

 

Navigation

[0] Message Index

[*] Previous page