Maintenance & Technical > KX250 / KX125
90 KX250 rebuild
SOHC:
--- Quote from: Caddy 16v on October 24, 2015, 06:36:29 AM ---
--- Quote from: SOHC on October 21, 2015, 07:29:18 PM ---I am unsure witch is left and right for the upper radiator hoses, one is different, at a gess I would say the shorter one goes to the tall left hand radiator?
Both my radiator hoses look more like the one on your left side, the one with the "slight" bend. They must have changed the design a bit in the aftermarket hoses.
There are a couple pics of the hose setup in my build thread.
--- End quote ---
Yes my old hoses both had the 90 bends in them, I put the 90 degree one to the left as it had another bend in the top to match up with the top radiator pipe.
--- End quote ---
SOHC:
My chain guide was chewed up so badly I threw it away, I got this one witch is ok, I had to make a new nylon block for the bottom part
Dented pipe
Shed it full of junk as the house is getting work done on it, I would like to get plastics kit and a DG pipe and I have a Suzuki RM front numberbord on it witch sucks.
I just need a clutch kit and an air filter + chain and sprockets.
SOHC:
all that nice work has kind of disappeared into those s**tty plastics :-(
SOHC:
Have the plastics a good sand and a buff and they are OK, seat cover is getting fitted.
sandblaster:
Here is how to restore your plastics.
https://www.youtube.com/watch?v=n5JLhBEcROc&feature=youtu.be
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version