Maintenance & Technical > KX250 / KX125

90 KX250 rebuild

<< < (9/25) > >>

SOHC:


I just printed one out to test.

SOHC:
Got a good 2nd hand crank with a rooted hotrod kit in it but I have a new Japanese prox.



this is old junk from the motor.

SOHC:
Will a head gasket from a 1992 work? it measures about 0.7 of a mm bigger uncompressed than the old compressed 1990 gasket  

SOHC:
I also had to make a new locator pin for the head, a peace of #8 wire was the same size

SOHC:
What way round dose the water pump seal go? non spring side to the water?

also here is my water pump conversion, I plan to fit a late model water pump as the old ones are hard to find, it looks like it will work with a little work. 

Navigation

[0] Message Index

[#] Next page

[*] Previous page