Maintenance & Technical > KX250 / KX125

Best way to go replacing a '01 bottom end

<< < (9/9)

needsatopend:
All together now



Here is the home made 2 in 1 case splitter / left case installer

Center threaded rod has a rounded end at one end for a case splitter,  and a thread adapter at the other end to grab the crank at the flywheel side



Clutch basket holder tool

needsatopend:
All done :D



Beside the DX

Actionman:
Before I got my 2000, I thought kx's were ugly as hell (Im a suzuki RM fan); but with a set of green side panels the L models are very nice looking bikes. White is ok as well tho. You did a good job!

sandblaster:

--- Quote from: Actionman on September 02, 2015, 02:14:22 AM ---One thing I do is take a piece of 1000-2000 grit sandpaper and smooth any rough edges around the skirt, intake window, and side pockets where the pin slides in. I do that on any piston I use to keep stress fractures from forming.

--- End quote ---

I also do it to keep the sharp edges from scraping the oil off the cylinder walls during break in.
It may be unnecessary but I feel better doing it.

Navigation

[0] Message Index

[*] Previous page