Maintenance & Technical > KX500 Aluminum Frame Conversion (AFC)

Newbie building an 06 KX450f with 93 KX250 engine

<< < (2/3) > >>

scooterVOOII:
Sandblaster, yours doesn't look like that, because that's the 4-stroke airboot on that bike, in that last pic. Need the proper one, plus the adapter plate to make it work. Although, if you're Fanelli, you just use "s**tter pipe" to connect the carb and boot, the way they are now. Lol

A.Frame187:
I found a blown up 02 kx250 that I could probably own for $500.. Do you think that airbox boot would work? I guess I'd have to check to be sure.
Are the motor mounting points the same from a 93 to an 02? I've heard yes and I've heard no..  I figure if I get that blown up one is just a top end, I can get that motor rebuilt and eventually swap that in.
I also need to figure out an exhaust. I have nothing as of now. That blown bike just has stock, but it will give me something to start with.
Thanks again guys.

A.Frame187:
I bought a airbox off a 94 kx250 on eBay for $16 shipped. So I figured that would be a cheap test

A.Frame187:
So the 94 air boot doesn't look like it will work... It is too big to fit between the shock and the frame.. The shock will wear thru it. Sandblaster, which frame did you end up using? the CR or the KX?
open to any other Ideas you guys might have.. Thanks Aaron

sandblaster:
We used a 07 KX450f frame

Navigation

[0] Message Index

[#] Next page

[*] Previous page