Maintenance & Technical > KX500 Steel Frame Conversion (SFC)

2003 KX 250 SF Conversion

<< < (39/76) > >>

umberto:
Here is a picture of the bracket I did for the coil.  It keeps it away from the engine and doesn't rub anything.

skunkworks:
awesome build mate !

umberto:
Thank you skunkworks!  I've had a blast building it.

umberto:
Happy New Year everyone!  For New Years I decided to try out bronchitis to see if I like it.  I think I agree with Sweet Brown:



Since I'm stuck inside anyway, why not annoy the wife and go out to the garage instead of resting.   :evil:  After my last ride I decided that the front brake needed an upgrade.  Thankfully I had some bonus bucks and a couple of gift cards to Rocky Mountain, so I picked up this dude:


https://www.rockymountainatvmc.com/p/765/35148/Tusk-Oversized-Floating-Typhoon-Brake-Rotor-Kit-Front?term=tusk+oversized+rotor

It is a substantial upgrade over the stock sized disk I had:



It does not list as compatible for an 03, but the caliper will bolt up without any brake line issues, and it will work with the Tusk wheels I have on the bike (2004 and up).  I stated in a previous post that I was able to use the wheels with two brake side spacers, but I forgot to add that I needed to adjust them down a bit to work.  The brake side is approximately 33.50 mm and the other side is approximately 32.50 mm.  I would start with them a little larger than those measurements and work your way down to the right size.  I started with the brake side to center the rotor in the caliper, and then adjusted the other side until the wheel fit.  It's not a ton of adjustment, but it does need to be done to use the wheels.  

Here is a final pic with the rotor fitted and ready to haul Goliath (my father's nickname for the bike) down from speed:



I've got a couple more fun mods to try out before I'm done with her.  Then it's time to blow her apart and address the unpainted welds and general appearance.  I think I really like the looks of this 250 Foxx posted.  What do you guys think?

sandblaster:
I think your doing a great job.
Just keep doing what your doing  8-)

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version