Maintenance & Technical > KX100 / KX85 / KX80 / KX65 / KX60
Pro taper with no crossbar
Foxx4Beaver:
--- Quote from: BLACKBEARD on February 05, 2015, 01:19:46 PM ---So I guess I gotta get the adapters?
--- End quote ---
yup...quick and easy swap....but I would call them when ordering to be sure you get exactly what you need. I prefer the solid mounts, as they eliminate vibration, but it's personal preference.
http://www.protaper.com/products/handlebars/bar-mounts
BLACKBEARD:
I was looking around on their website and I DID see the mounts, but I also seen that there is a s@$! load of bend variations. Without seeing them I couldn't make an accurate decision on which ones to get. What is the most common one?
Foxx4Beaver:
--- Quote from: BLACKBEARD on February 06, 2015, 09:50:44 AM ---I was looking around on their website and I DID see the mounts, but I also seen that there is a s@$! load of bend variations. Without seeing them I couldn't make an accurate decision on which ones to get. What is the most common one?
--- End quote ---
haha...yeah it can be a little bit of gamble, "hoping" you actually like the bars you get...
if you're happy with the ones currently on it...you'll have to use the chart to figure out which ones you have(or at least close to)...then increase/decrease any bends/sweep/rise...etc, that you feel you might like better.
example chart...scroll down
http://www.protaper.com/products/handlebars/fuzion
or if you feel you want more, or less "sweep" or "rise"...the chart provided will help.
I run Renthal RC High bars on both my 250 & 500, but I couldn't say that they would be any good for your application.
Navigation
[0] Message Index
[*] Previous page
Go to full version