Maintenance & Technical > KX500 Aluminum Frame Conversion (AFC)
2006 kx500af Done Building, Needs Tuning
crooscroos:
Can you post some pictures of your plexiglass plate? I'de like to see it!
I'm going to post a picture of my piston late tonight or tomorrow.
As for my motor mounts, I am installing rubber spacers in an attempt to minimize some vibration!
cmotodad:
I do not have the bike any longer. I just traced the crf inner box and then matched the boot to the carb side. I used flat carriage bolts to hold the plate to the box. Did the same thing with the boot to the plate. Any bolts that were on the air cleaner were flat and did not create an issue. I used a gas resistant sealer to seal the plate to the box and boot to plate. Good Luck
crooscroos:
Here is a picture of the top of my piston! It looks pretty normal but you guys have more experience with jetting than myself!
crooscroos:
Here is a side view of my piston, the damage done by the sand was'nt terrible and the rings are still in good shape. I'm glad I took the bike apart when I did!
sandblaster:
Did you clean the top of the piston before taking the pic?
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version