Maintenance & Technical > KX100 / KX85 / KX80 / KX65 / KX60

coolent

<< < (3/3)

Foxx4Beaver:
you're welcome :-)

I should mention that it would be a good idea to check your manual for coolant adding procedures...I'm unfamiliar with the KX100, so I'm not sure if there is anything to be cautious about while filling the system...such as bleeding air from it. There might be a cap on the left rad that should be removed while filling it, I'm not sure. 

B1G Y1N M4N50N:
Aye Av already flushed the stuff that was in before. Soo it shud be as easy as adding it into the radiator

Foxx4Beaver:

--- Quote from: B1G Y1N M4N50N on January 07, 2015, 04:16:12 AM ---Soo it shud be as easy as adding it into the radiator

--- End quote ---

it should be, but it wouldn't hurt to look into it either, just to be sure.

B1G Y1N M4N50N:
Ok bud al give it a look up. As Av not got the manual fur it.

Foxx4Beaver:
you could always call your local Kawie dealer, and hopefully you'll get someone that actually knows the answer....
or you could just keep an eye on the coolant level after it's been warmed up and run for a bit, and see if you need to add any.
I know on the 250's, there's just the plastic cap on the left radiator, that you're supposed to unscrew whilst filling the system to allow any air to bleed out.

Navigation

[0] Message Index

[*] Previous page