Maintenance & Technical > KX500 Steel Frame Conversion (SFC)
Quick winter 2005 RM-z500 build
ddashb:
Here's what we got so far. Did what we could to line the output shaft hole with theswingarm pivot but left off the final tabs until i get ahold of a cylinder head (help would be great).
ddashb:
Laid down a ton of extra weld to make sure we had enough to grind off to clean it up.
ddashb:
ddashb:
cmotodad:
Looking good. Maybe put an extra gusset on the bottom by foot pegs.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version