Maintenance & Technical > KX500 Aluminum Frame Conversion (AFC)
1990 KX 500 to 2006 KX450F Conversion Project
don46:
and as for a pipe from Service honda, you will still end up denting it around the water fixture if you don't use the up pipe on the water nipple. The CPI fits like a glove but its expensive and big so it is probably susceptable to denting.
don46:
--- Quote from: Kwackerman on February 17, 2015, 01:04:56 PM ---Here's a look at here from yesterday, from the back left side.
--- End quote ---
is this a MPS conversion?
don46:
never mind I went back to the beginning
Kwackerman:
That's great news about the hose. I wondered if anyone other than SH had those.
I'll call my buddy to see if he's already cut the pipe. If he hasn't I'll tell him to hold off till I can get a hose. That'll save me some $.
sandblaster:
--- Quote from: don46 on February 17, 2015, 01:03:28 PM ---
I will also say that the first AF framed bike I did was similar to your frame rails, I will caution you to watch them very closely because they will break, after the second time I gutted it, bent all new frame rails using radiused tubing and gusseted both the top and bottom.
--- End quote ---
Hey Don.
Just curious, did you heat treat the frame when done?
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version