Commercially available service offered by members of KXRiders. > OEM-CYCLE
2 piece clutch covers
motopunk:
--- Quote from: sandblaster on August 03, 2015, 02:32:07 PM ---My bike doesn't leak and I change the oil so often that the site glass isn't really necessary.
It would be cool but Then I would need a ream of the correct size :-D
--- End quote ---
the glass is not really necessary .. an oil level screw will do the same work and is easier to fit to the cover.. :wink:
to refill the tranny open the level screw, fill the tranny, till oil shows up through the hole . drain it till only little less oil comes there, put the level screw back in, ready... 8-)
i know this from old german bikes .. and boyesen offers aftermarket clutch covers, that have the level screw instead of the glass...
mikectanker:
I called Rekluse and they said the bike has a regular manual clutch. They didn't really want to the Drz 400 one since they are afraid it won't hold up. Anyone have any info or advice before I spend more on a revloc? (If I can get one.)
umberto:
EnduroPilot.com is a place you could contact for a Revloc. I bought my 04 KX250 Rekluse there, and the guy I spoke with (Tom) said they are buying up old Revloc stock wherever they can. I called 319-465-5001, or you can go to http://enduropilot.com/.
mikectanker:
Its funny you said that Umberto bc i was on the phone with Tom just now before reading your reply.
Tom seems to know his stuff.
He said that Rekluse bought revloc out.
The recommended fix is to get 1 more friction plate in there.
To do that I'm going to see if I can get a one of my friends to grind a little off of each steel plate so I can run an extra friction plate with a kx450 rekluse.
So if we want auto clutches for our bikes theres more hoops and ladders to go through.
umberto:
Tom is a good dude. I wonder if he would produce a kit if enough people were interested. I'm pretty sure that more than a few people on here want one, and if it just involves some adjusting to the steel plates, maybe Tom could produce a kit to use the KX 450F clutch. Might be worth asking about.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version