General > In General...
jetting recommendations
saki5ridr:
just bought rad valve have 2002 kx500 currently running at 30 ft above sealevel in high humidity 95 degree summer days in Florida runs on 93 octane chevron pump gas mixed 40:1......39mm pwk currently has 168 main 58 that I think is a little too rich the needle is stock & in on the second position bike has fmf gold series gnarly with pc 304 silencer ngk br8eg plug does anyone have any jetting recommendations for this new radvalve setup? thanks for your time and input!
bens87braap:
i dont have a 500 but have read lots on here and found this from Sandblaster
Re: 01 kx 500 performance upgrades?
« Reply #10 on: Today at 09:36:50 AM »
Reply with quoteQuote
At sea level to 1500 ft my 3 KX500's all run perfect with a 168main 55 pilot just as Foxx4Beaver suggested.
Do a search lots on jetting here
sandblaster:
Supermoto
PC2 pipe
Turbine Core muffler
Vforce 2 reed on high tension setting
Head squish mods and compression release
Wossner windowed piston
Balanced crank
Transfers, ports, and bridges have all been cleaned but stock port timing
41mm Keihin
55 pilot
168 main 3rd position on stock clip
92 clear gas
40:1 Motul 800
0-1500 ft
Sand bike
PC2 pipe
Turbine Core muffler
Vforce 2 reed on high tension setting
Stock carb
55 pilot
168 main 3rd position on stock clip
92 clear gas
40:1 Motul 800
0-1500 ft
Foxx4Beaver:
--- Quote from: saki5ridr on August 04, 2014, 09:37:15 PM ---58
--- End quote ---
that's a lot of pilot!...
I'd drop it to a 55 to start...but don't be surprised if you need to drop to a 52, especially if you do a lot of slow speed trails.
saki5ridr:
Sb...slightly massaged huh ha...sounds nice! info is appreciated not sure if I posted it in the right spot thanks Would like to see pic if u get chance..thanks
Navigation
[0] Message Index
[#] Next page
Go to full version