General > Introductions
New Finnish KX500 rider -Now with pictures-
TimoR:
I did the porting by myself. 8-) It was not the first one though :mrgreen:
zavu:
Welcome TimoR
Very Nice work :-) Did you repair do yourself? If someone helped you?
Foxx4Beaver:
excellent!
the place that makes those swing arm decals, factory efx, are a half hour down the highway from me in New Bedford...they make all kinds of cool graphics and designs.
sandblaster:
Nice job TimoR.
Did you take pics of your port work?
I'm always looking for something special 8-)
TimoR:
I like to do as much as possible by myself but suspension things I`ll leave for a specialist. I do the engine rebuilds, porting, sand blasting etc. But, sorry, no pictures about the porting job although there is no secrets, some polishing, sharpening, the usual things. There was a lot of work with the cylinder because of not so good cylinder sleeve, the transfer ports were so poorly in their correct place :x I also adjusted the KIPS valve with correct length bolt so that the ports are closed when idle. Now I`m waiting the reed spacer from Moose Racing and a new float valve for the carb.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version