General > In General...

Engine Questions

<< < (2/2)

Rowdy-Yates:
AHHH that sounds easy ill check it out when I change the water pump seal.

KXcam22:
Rowdy,
   Lot of good advice there. I normally get gray in my trans oil from the aluminum clutch plates wearing. I think water usually colors it alot whiter and milky looking. The exhaust spooge can also be the brand (and mix) of oil you run.  I was running Belray HR-1 (@60:1) last year in mine and my kids bikes and was getting lots of spooge, even with crisp jetting.  I switched back to my favorite MC-1 (@60:1) and the spooge vanished!! Interresting. Cam.

Rick:
Switch to steel plates and not only eliminate confusion about water or aluminum contamination, but steel plates last forever.  I actually pulled mine from my 1999 and slapped them into the 2002.  I have fours years on them now, and still going strong.

Rick

Navigation

[0] Message Index

[*] Previous page