Maintenance & Technical > KX500 Aluminum Frame Conversion (AFC)
Dutch 500AF Conversion 250KXF 2009
Jos197AF:
My girlfriend is becoming not happy at all..... I am starting to fall in love with my bike....
jBernard:
woah is that your pipe? i'd say thats a cr500 one from scalvini but i see that cut off on the table. NEED more info!
Jos197AF:
--- Quote from: jBernard on March 29, 2014, 06:33:53 AM ---woah is that your pipe? i'd say thats a cr500 one from scalvini but i see that cut off on the table. NEED more info!
--- End quote ---
My bike, my exhaust. Not a scalvini, but a special made exhaust for my bike. Not finished yet, right side has to be done also. This is just the beginning.
jBernard:
wow you are hauling ass on this project! that is impressive.
i'm wanting to do the EXACT same thing.
couple questions:
- what software did you use to plot the expansion chambers?
- cut the sheet metal out by hand or laser jet?
- how did you roll them? slip roll?
- tack the whole thing up, then purge the inside and weld completely or weld each slice fully at a time?
motopunk:
--- Quote from: Jos197AF on March 29, 2014, 06:13:16 AM ---My girlfriend is becoming not happy at all..... I am starting to fall in love with my bike....
--- End quote ---
i can understand you...this is an very sexy looking exhaust... :-D
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version