Maintenance & Technical > KX250 / KX125

Best low end-mid pipe for 98 kx250

<< < (13/13)

Foxx4Beaver:
awesome...thanks for sharing that!!

dirk_411:
I stand corrected.  I for some reason had it in my head that the oem power valve mechanism balls were stainless steel.  They are NOT stainless.   Void my reference to stainless

Foxx4Beaver:

--- Quote from: dirk_411 on March 13, 2014, 08:10:49 AM ---I stand corrected.  I for some reason had it in my head that the oem power valve mechanism balls were stainless steel.  They are NOT stainless.   Void my reference to stainless

--- End quote ---

ahh....have you been able to determine what they are?

bumpnzx3:
I hate to bring this one back from the dead, but the last couple pages are directly dealing with what I'm working with....

Does anyone know the result of running a '99 power valve governor with a '00 engine? The later model appears to have a slightly larger diameter. I ask because I bought a replacement inner clutch cover for my '00. I thought they were all the same, but my '00 governor is a bit too large to fit inside the inner clutch cover. Trying to decide if I should get the correct inner clutch cover or if I can just swap over to the '99 governor (cheaper).

sandblaster:

--- Quote from: bumpnzx3 on November 25, 2015, 04:11:10 AM ---Trying to decide if I should get the correct inner clutch cover or if I can just swap over to the '99 governor (cheaper).

--- End quote ---

Besides, your 99 governor already shipped  :lol:

Navigation

[0] Message Index

[*] Previous page