General > In General...
oil check
Foxx4Beaver:
be sure to verify your float height is set correctly before you touch any jets, then go small increments at a time when it comes to changing jets.
staffylad:
the float was stuck at first so I cleaned it all out didn't look like it been cleaned since 1994 lol looked like soap powder sugar type decay cleaned all that out now just need set the jets n idol :evil: :evil:666
sandblaster:
I haven't finished writing it yet but here is some good info on adjusting your float height.
http://www.oem-cycle.com/forum/viewtopic.php?f=40&t=586
There is enough info there for you to get the basic idea...
Thanks goes to Motorrad for the idea.
Foxx4Beaver:
--- Quote from: sandblaster on December 27, 2013, 06:51:24 AM ---I haven't finished writing it yet but here is some good info on adjusting your float height.
http://www.oem-cycle.com/forum/viewtopic.php?f=40&t=586
There is enough info there for you to get the basic idea...
Thanks goes to Motorrad for the idea.
--- End quote ---
Yup...externally is the BEST way to set/verify float height...period.
staffylad:
cheers looks like a good way to test the fuel bowl level that with a drain plug nozel welded on wat kind of nozel is it thoe wer would I find one ,seem high level wat Kawasaki recommend like doesn't it
:evil:
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version