General > In General...

is this ok?

<< < (2/3) > >>

sandblaster:
Again referencing the manual for the 88 kx125
Big end of rod side play New .40-0.50 mm
Service Limit 0.70 mm or .028"

J.ellwanger:
I have not done any measuring...
 Guess i should get on that. And as far as age I'm not sure
How Long its been in the bike,   and also i have  not checked the  bottom of the rod, i have been spinning the crank, and haven't found anything blocking or stuck, but i have inspected the whole  piece, just not the rod itself, (looking for missing skirt ) but since I've found the skirt in a thousand  pieces in my exhaust,  I'll start looking and measuring all the specs on the bottom end

J.ellwanger:
so did i ask a dumb question thats not worth an answer?

sandblaster:
I've been out of town.
What was the question?
Also, did you measure the crank?

Motorrad:
Id be concerned the skirt is wadded up in one of the bearings, or smeared in the race.... (mains)   it probably isn't. but I always think of worse case.

don't wory about the texture.


measure runout

Navigation

[0] Message Index

[#] Next page

[*] Previous page