Maintenance & Technical > KX500 Aluminum Frame Conversion (AFC)
Kx500 Factory KAWASAKI FRANCE, conversion Frame HONDA CRF450
motopunk:
--- Quote from: Broesel33 on April 08, 2013, 07:41:44 PM ---
--- Quote from: hulkteam476 on March 22, 2013, 06:53:13 AM ---this frame work wonderfully in supermoto with this triple clamp offset adjustable 14/16 20/22 23/24mm. This product is available through Paypal sent into the world with only ups for cr / crf / kxf. (details on request.)
--- End quote ---
Hi,
where can I buy these triples?
I´m looking for crf ones.
Thanks.
Sorry that I didn´t start a own thread. Because I´m building an AFC with a KTM engine and a Hondaframe.
I´m reading here find a lot of superb ideas to build a bike.
Thanks guys.
If I find a good Kx500 engine I will build one :-)
--- End quote ---
hi broesel33 welcome to this site... which motor and which year of frame you use for the conversion?
i loved the powerful 380cc motor but i hated the pds-shock when i rode a buddies bike. this motor needs a good frame shocks and linkage around, to show his full potencial . you could start a thread in "my other bike" here on this site. i want to see pics. i love the green mashines, but i´m interested in all spezial build mx-bikes. :-)
hulkteam476:
impossible to see the pictures that illustrated my post how to change this and make reappear images?? Motorrad??
motopunk:
--- Quote from: hulkteam476 on March 14, 2014, 08:32:40 AM ---impossible to see the pictures that illustrated my post how to change this and make reappear images?? Motorrad??
--- End quote ---
you need now a photohoster like photobucket, picasa or so... it isn´t possible to post pics directly from pc since fall last year...
jBernard:
really want to see these pictures back up!
hulkteam, im going to try and do a hydraulic clutch as well. mounted like the brembo on the side of the case.
one question i had was how do you determine its positioned straight in line with the pushrod. and also how do you find out the length to make the clutch actuator rod. i would think that the rod would need to be custom made because of the hydraulic version would be further out than the internal stock mechanical one?
Navigation
[0] Message Index
[*] Previous page
Go to full version