Maintenance & Technical > KX500 Aluminum Frame Conversion (AFC)

Billet Y Piece for Frame

<< < (2/2)

ID KX500:
Might be worth it to me if the machining ran all the way with the bottom motor mounts solid also. But probably not possible or too much aluminum and waste.

LundMx:

--- Quote from: ID KX500 on March 03, 2013, 06:25:51 AM ---Might be worth it to me if the machining ran all the way with the bottom motor mounts solid also. But probably not possible or too much aluminum and waste.

--- End quote ---

X2 ^

agentwilliams:
The main downtube on a KX250F frame is 1.875 square, so this doesn't work anyway.

Charlie500:

--- Quote from: agentwilliams on March 06, 2013, 12:25:35 PM ---The main downtube on a KX250F frame is 1.875 square, so this doesn't work anyway.


--- End quote ---

This would be sweet if it worked.... Someone should get one set up for the kawasaki and start selling them..... Would make life a lot simpler....

Navigation

[0] Message Index

[*] Previous page