Maintenance & Technical > KX500 Aluminum Frame Conversion (AFC)
2011 kx250f conversion w/ 1988 kx500 (Newbie)
LundMx:
I extracted the "y" peice from my down tube today.. It came out pretty dam good i think!
LundMx:
So i made more progress today :lol: i made my measurements for the cut to move up the "Y" piece, so check it!!!
I realized that i needed to cut out A LOT!
But after a lot of trimming slowly and precisely I finally got a fit that was like a glove!
And what do ya know :lol:!!
So this weeks challenge is going to be bending the square tubing for the engine cradle, i need to make some more mounts obviously, but i smell premix in my soon future!
Motorrad:
almost like it was ment to be :-o
LundMx:
Hey motorad, is jfab still making products? Im going to need help with these frame rails
Motorrad:
--- Quote from: LundMx on March 24, 2013, 04:51:10 PM ---Hey motorad, is jfab still making products? Im going to need help with these frame rails
--- End quote ---
last I checked.... You have to call him at the shop though.
His phone number is at the beginning of any of his posts in the vendors section.
Report back
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version