Maintenance & Technical > KX500 Aluminum Frame Conversion (AFC)
'09 500AF build
ylwgtr:
im just running a hose on it down beside the intake (with a wire holder like on the left side of the reed cage for the CDI wire) then down through the metal band the overflow tubes run in behind the engine and out under the bottom
ylwgtr:
just had a look....you could route it into the front right hand side of the kips chamber on the cylinder....the side valve is open at starting time so it would dump it straight into the exhaust pipe :) not sure of any side effect of blow back whilst running though,maybe crap building up in the pipe?...id need to have a bit more of a think about it
ylwgtr:
ylwgtr:
I whipped this up in a few minutes today....I'm thinking there is enough material on the cylinder to drill/tap and I will prob put it in the mill and take a drop in with a large end mill .3 of a mm to make a sealing area for a copper washer...what do you guys reckon?
Anyone see an issue apart from having to clean the tube/decomp valve when servicing the powervalves??
ylwgtr:
Ps....sorry for cluttering up your thread... :-(
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version