Maintenance & Technical > KX500 Super Motard
2001 KX500 Kawasaki Supermoto
Larry Wiechman:
--- Quote from: sandblaster on August 08, 2015, 01:17:41 PM ---This is all for now.
Still gotta weld up the compression reliefs so no sense getting carried away.
--- End quote ---
I guess it's too late to say "Don't lower the bottom of the main exhaust port."
sandblaster:
--- Quote from: Larry Wiechman on August 10, 2015, 02:38:23 PM ---
--- Quote from: sandblaster on August 08, 2015, 01:17:41 PM ---This is all for now.
Still gotta weld up the compression reliefs so no sense getting carried away.
--- End quote ---
I guess it's too late to say "Don't lower the bottom of the main exhaust port."
--- End quote ---
Nope, haven't touched it :-D
In fact I have to cut the top of the exhaust port back to the stock specs as it has been welded up.
sandblaster:
Something huge showed up last week..
There was no "M" markings but if you know what to look for you can see the "M" touch on it...
Pmcg:
--- Quote from: sandblaster on September 06, 2015, 08:46:55 AM ---Something huge showed up last week..
There was no "M" markings but if you know what to look for you can see the "M" touch on it...
--- End quote ---
I'd sure like to know more about that carb
sandblaster:
Me too 8-)
I know it is a 44mm Lectron with a cool choke set up on it.
I gotta get it on my bike one of these days...
I doubt I have enough port timing to make full use of it but we will see..
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version