Maintenance & Technical > KX500 Super Motard
2001 KX500 Kawasaki Supermoto
sandblaster:
I had to make a adapter for my degree wheel.
Since I don't have a lathe, I decided to use a old fly wheel.
I didn't want to ruin a KX500 fly wheel so I used one from a 99 KX125.
As it turns out they are exactly the same shaft size.
I ground off the rivets...
Did a test fit on the shaft to make sure nothing had changed...
Carefully drilled the holes to maintain alignment..
It bolted up and worked perfect....
Now I need to make the pointer for the degree wheel...
Where's the welding rod ?
Motorrad:
Sweet
sandblaster:
I looked at my bike today... then walked away...
Motorrad:
--- Quote from: sandblaster on August 20, 2013, 02:04:58 PM ---I looked at my bike today... then walked away...
--- End quote ---
been doing that for about a month and a half now.
81cr450:
--- Quote from: Motorrad on August 20, 2013, 02:07:16 PM ---
--- Quote from: sandblaster on August 20, 2013, 02:04:58 PM ---I looked at my bike today... then walked away...
--- End quote ---
been doing that for about a month and a half now.
--- End quote ---
Both of you eat Toads, least it aint still in a bucket. Get out & ride that :mrgreen:
I got reed's on the way & I think the welding "might" be done on the jug. The rest is $$$, & you 2 are just looking at yours :cry:
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version