Maintenance & Technical > KX500 Aluminum Frame Conversion (AFC)

JFab frame rails breaking

<< < (9/9)

jBernard:
daily?
just for clarification last time he was on this site was over 2 wks ago and it was at 1AM.

i think you may be putting to much emphasis on JFabs rails for this guys complete build. Jfab just bends the aluminum rails. and from what i know about bending square tube, he has a pretty nice machine to have the radii looking like that, so its definitely not a hack job.
jfab doesnt make the motor mounts, he doesnt make the headstay, he doesnt make the yoke, he doesnt weld, he doesnt fit, he doesnt give instructions on the fab work. we havent singled out what the issue was that caused the problem, so calling out 1 particular thing is jumping the gun a bit i think.

Navigation

[0] Message Index

[*] Previous page