Maintenance & Technical > KX500 Aluminum Frame Conversion (AFC)

Next project

<< < (2/3) > >>

Motorrad:
Pics up for Trim..   :-D

jBernard:
rails look good, only see a bit of crimping before the radius. what did you use to bend them?

trim:
I used a Ercolina CE40 MR3 Angle roller with 6061 tube

jBernard:
ah. why did i even bother asking with that badass shop in the background :lol:

ive been asking local shops around here and no one has square dies for some reason.

trim:
I didn't use square dies just the flat part of small diameter pipe die. If bent with light pressure and run it through slowly it will not crush the tube

Navigation

[0] Message Index

[#] Next page

[*] Previous page