Maintenance & Technical > KX500 Steel Frame Conversion (SFC)

my 03 kx 250/500 build

<< < (3/6) > >>

81cr450:
use the cr500 silencer, is has to bend up where the k5 silencer just goes straight out

Hope you get healed up quick

Suva:
OD the 250 pipe is fine, much smaller inside dia. than the 500 though

81cr450:
If you have a lathe you could probably chuck that 250 snout up & turn the inside out to the 500's inner pipe diameter. Save hunting up one from a k5

Suva:
don't know about the rest of you, but I still had to put a nice bend in the CR500 silencer to get 'er bolted up.  Curious if the silencer offered by Service Honda doesn't fit better, as I'm sure I lost some flow due to the bend in mine...

The Flyin Hawaiian:
I didnt bend anything on mine. I used a homemade bracket similar to the rear bracket on a KX500 to hang mine. I wanted to be able to swap out the exhaust w/o any modifications.

Navigation

[0] Message Index

[#] Next page

[*] Previous page