Maintenance & Technical > KX500 Aluminum Frame Conversion (AFC)

Exhaust port not centered!!!

(1/2) > >>

MOTOSCOTT:
2008 kx250f/92-500
Got in contact with Jfab and rails on the way!
 Cut my frame rails and prepped.
 Drilled my pivot with 43/64 and the fit is perfect.
 Fine tuned the outer swingarm spacers :? to get a nug fit for the rear engine/swing arm/frame. Installed my motor to get a feel for the final cut for the correct height for the exhaust pipe and !!!!!!!!!!

My exhaust port is about an 1/8 of an inch off center to the left of the front frame down tube. Is this normal? I dont think I have enough to trim in the swing arm spacers to compensate. Chain alignment looks O.K.

Any suggestions.
NO PICS YET COMMING SOON (CAMERA DOWN)

Motorrad:
Hmm thinking what it could be..     

Waiting on pics

sandblaster:
I took a look at my unfinished project and my outlet is split evenly.
So I looked at the possibilities.
Bent frame
Bent pivot pin
Misaligned holes in the engine cases.
Oblong holes in the frame.
What else could it be?

kwakman:
does it line up if you slacken all the bolts up? if not, twisted frame would be a possibility.K.

jonny500:
did you take the same amount off both swing arm bushes

Navigation

[0] Message Index

[#] Next page