Author Topic: tdc tool  (Read 14834 times)

0 Members and 1 Guest are viewing this topic.

Offline YUNGGUNNAZ

  • Full Member
  • ***
  • Posts: 219
Re: tdc tool
« Reply #15 on: November 09, 2007, 06:03:50 AM »
good information to put out there for everyone that does their own motors.and with a bearing in the big end it probably is more.good topic for research.motor happen to be a 4mil banshee.not far from jet ski.

crusty

  • Guest
Re: tdc tool
« Reply #16 on: November 30, 2007, 04:21:08 AM »
great idea man good to see ingenuity at work  :evil: :evil: :evil:

Offline demographic

  • Hero Member
  • *****
  • Posts: 822
Re: tdc tool
« Reply #17 on: December 02, 2007, 05:37:01 AM »
Just thought I would put a few downloadable degree wheels on this thread, just copy them and stick them onto a scrap of aluminium and drill the centre.
http://www.tavia.com/free_degree_wheel.html
http://www.machinerycleanery.com/DWUniversal.htm
http://swarfrat.com/DegreeWheelDownload.htm
I put a few links on there cos that gives anyone a choice and means that if one of them turns into a dead link over time theres another to use.



Offline kwakman

  • Hero Member
  • *****
  • Posts: 879
  • Kwikasfuki KX500
Re: tdc tool
« Reply #18 on: January 05, 2009, 12:04:50 PM »
f**k it, I'll have two.
And lo, I did loft the front wheel and carried it forth to the unbelievers, and cast it down before them and said unto them ''look now upon the might of my throttle control ye pitiful cretinous ones''
And the unbelievers did quake in their boots....

Offline PowerFiend

  • Full Member
  • ***
  • Posts: 169
Re: tdc tool
« Reply #19 on: May 22, 2009, 04:49:43 AM »
Any reason you didn't leave the hex portion of the plug?

Offline BDI

  • Hero Member
  • *****
  • Posts: 1,533
Re: tdc tool
« Reply #20 on: May 22, 2009, 05:19:26 AM »
It only needs to be screwed in hand tight.
Smoke every cigarette like It's your last and ride like you stole something!!!