Author Topic: shift shaft holding up right side cover?  (Read 495 times)

0 Members and 1 Guest are viewing this topic.

Offline Borntworide

  • Jr. Member
  • **
  • Posts: 25
shift shaft holding up right side cover?
« on: April 14, 2020, 07:47:23 AM »
Is it possible for the shift shaft to hold up the right side cover? The notch in the cover is hitting the top of the shift shaft no allowing cover to seat flush?

Offline KXDINO

  • Hero Member
  • *****
  • Posts: 576
Re: shift shaft holding up right side cover?
« Reply #1 on: April 16, 2020, 04:39:17 PM »
Can do but make sure shift shaft not touching bench as well when you bolt it up as it can damage side cover , also check kickstart plastic spring holder is in properly and not worn in the groove , had a ktm do this it kept slipping out only a bit , but just enough to hold it out.

Offline oldmxer95

  • Newbie
  • *
  • Posts: 7
Re: shift shaft holding up right side cover?
« Reply #2 on: April 17, 2020, 02:47:09 AM »
If it is the shift shaft not allowing the cover to fully seat, I would make sure all of the shifting mechanism is assembled or fully in place.

Offline Borntworide

  • Jr. Member
  • **
  • Posts: 25
Re: shift shaft holding up right side cover?
« Reply #3 on: April 24, 2020, 09:39:46 AM »
Fixed !!! It was the shaft washer that moved out of place !!