KX Riders

Maintenance & Technical => KX100 / KX85 / KX80 / KX65 / KX60 => Topic started by: linetrash1975 on April 27, 2011, 11:54:06 AM

Title: crank seals which way in
Post by: linetrash1975 on April 27, 2011, 11:54:06 AM
 Which way do I install the crank seals in my 95 KX60? Wire spring out or wire spring in towards crank. I'm guessing wire seal goes toward oil in the Tranny but what about the flywheel side?
Thanks Jed
Title: Re: crank seals which way in
Post by: Magnus on April 27, 2011, 12:56:06 PM
pretty sure the side where the spring sits goes towards the crank, if I am wrong I am sure someone will correct me :-)
Title: Re: crank seals which way in
Post by: linetrash1975 on April 27, 2011, 02:01:40 PM
 Thanks magnus, I'll hold off a bit till I get a definative answer, don't want to splitt it again.

Jed
Title: Re: crank seals which way in
Post by: Motorrad on April 27, 2011, 05:17:32 PM
pretty sure the side where the spring sits goes towards the crank, if I am wrong I am sure someone will correct me :-)

Correct....