KX Riders
Maintenance & Technical => KX500 Original => Topic started by: Motorrad on February 04, 2011, 08:30:05 PM
-
Okay.. Playing with camera etc... (YES I know my bench is dirty.... motors not going together YET..)
Make sure you check it out in FULL SCREEN mode...
Not sure how good I will be at editing things together... still playing with that.. I have noticed one thing...
You look like you dont know how to use a screwdriver when your watching the camera screen instead of what your doing.....
1.Angle on this looks like I should move to my Lower bench... as this is as high as my tripod goes. and a more downward shot would be better for when Im doing tranny etc?
2. Would you like it in FULL 1080p?
3. Lighting good?
4. ??????
NOTE:
I have already cleaned out the bearings of grease, and oiled them up.. etc. Before I shot this.. just shot this as a test.. ... (My bearing house gets a better price break on sealed bearings... same bearing as non.... so I buy the sealed and clean em out... as there is a $10 price differance of sealed vs non sealed)
http://www.youtube.com/watch?v=vcb11gnm--c&hd=1
-
Very nice.
I'd love to see more how to articles on video.
Full 1080 is nice but for most things not necessary as long as your lighting is good and yours looks great on my screen.
-
Video quality looks great I don't think it needs to be 1080p. Lighting is perfect.
As far as the tripod vs bench height goes I would just build a little box to raise the camera. No point in making yourself uncomfortable just to get a good camera angle.
-
Looks like good video to me. A full case splitting video would be the cats meow. Theres always people looking for info on that all over the net.
-
Looks like good video to me. A full case splitting video would be the cats meow. Theres always people looking for info on that all over the net.
Unfortunatly cases are already split.. Not going to split again after assembly.. (as it will be right this time ;) ).
Going together video is what I'm aiming for here
-
Can't wait to see it :-)