KX Riders
Maintenance & Technical => KX500 Original => Topic started by: tunster on January 01, 2011, 05:16:09 AM
-
http://i838.photobucket.com/albums/zz302/tunster_2009/project%201988%20kx500/Photo0345.jpg(http://)
Never seen this happen before.Complete rebuild on its way.This is my basket case resto.
-
how the heck did that happen?????!!!!!!
-
i dont know.I bought it as a basket case and parted the motor today.When i took off the clutch cover the back of the clutch basket [the gear] had come away and the plastic spacers?? were mashed up everywhere.
-
i have seen that before, when i bought my k5 89 it was worse than that, at least you have some fingers on the basket lol. i got the mitaka basket. you have to press the center gear but the ring gear goes on using bolts. i had my doubts at first but but i gave it a good work out (to the point the engine gave up) and it was fine. heres some picks of the new basket dont have the old 1 and a sub frame its the only 1 i can find. it dead straight with a couple of small marks from the chain. threads look good too but will have to check them through properly
-
how much you asking for the subframe? Hopefully going to look at some stuff in the next few days but dont know what there is till i get there.
-
just pm me with an offer post will be about ?5
-
SEE PM
-
for some reason i cannot pm i have been having this promblem can you send me an email you will find my email address on my kxriderss profile
-
ok will do.