KX Riders
General => In General... => Topic started by: Fowler Racing396 on July 27, 2010, 01:07:35 PM
-
has anybody tried boring the 44mm mikuni vm out or know anyone who will do it?
-
Fowler,
Have you measured the diameter of that beer can of a slide? You should be able to bore the carb to just under that size as long as the intake has enough metal. I have a couple of the PWKs & they were cast with the centerline of the bore off centered & appears that the slots for the slide are the same, check your VM to see if it's centered to see if it would cause any problem.
DoldGuy
-
daniel
It depends on what you what the carb to do. You can cut it out to 48mm or 49mm with a custom slide. I would leave it at 44 at cut a 50 taper in it. The v-force cages get lazy on airflow after 46mm.
-
just trying to find a way to go faster. . . alot of these fast a,, banshees running 48mm 50mm carbs figured if i wanted to go faster i would need bigger carb
-
asked the same question about my 40 vm a while back but no closer to finding out how far they'll go.I reckon they'll do 44mm.I have always found it to be a good carb overall, but I havent tried the pwk.