KX Riders

Maintenance & Technical => KX500 Original => Topic started by: Uzi9mm on April 26, 2009, 03:30:15 AM

Title: V-Force II question.
Post by: Uzi9mm on April 26, 2009, 03:30:15 AM

I bought my 500 with a Rad Valve.  And no spare parts.  Does the V-force require anything special to fit?  Mods? Stock intake?

Title: Re: V-Force II question.
Post by: cbxracer30 on April 26, 2009, 03:46:35 AM

No special fit but it does require the stock intake boot and clamp. It just replaces the stock reed cage.

Title: Re: V-Force II question.
Post by: jfabmotorsports.com on April 26, 2009, 04:45:37 AM

You have to cut the ears that protrude into the reed cage off of the stock boot.

Title: Re: V-Force II question.
Post by: cbxracer30 on April 26, 2009, 04:53:16 AM

Sorry , Thanks Jfab its been so long since I put mine on I forgot about that , If you want bottom end stick with your Radvalve but for power everywhere else go with V-Force.

Title: Re: V-Force II question.
Post by: Uzi9mm on April 26, 2009, 06:40:50 AM

Thanks for the replies.   8-)

Title: Re: V-Force II question.
Post by: BDI on April 26, 2009, 08:08:19 AM

The v-force hase great power from bottom to top. I  not only cut the ears off but then I match the round hole to the square hole on the V-force. This is a picture of a junk rubber boot that I practiced on before I did it to a good one.

Title: Re: V-Force II question.
Post by: Hick on April 26, 2009, 02:11:24 PM

I put them on my 2003 k5 with jfabs reed spacer and im very happy.

Title: Re: V-Force II question.
Post by: Uzi9mm on April 27, 2009, 06:39:11 PM

Awesome reply!   8-)   Picture and all... Thanks!  I plan to order the V-force II this week.