KX Riders

Maintenance & Technical => KX500 Original => Topic started by: maher on April 20, 2008, 07:42:41 AM

Title: 91mm piston
Post by: maher on April 20, 2008, 07:42:41 AM

Hello!

Would I have to modify Kips, if I put 91mm wiseco piston in my kx500?

Title: Re: 91mm piston
Post by: don46 on April 20, 2008, 01:56:05 PM

yes you would have to weld shut the flapper, the rotarty drums are fine, or you could use a pre-89 cylinder. Where are you going to find a 91mm piston?

Title: Re: 91mm piston
Post by: kaw rider on April 20, 2008, 02:06:37 PM

why would you run a piston that big.

Title: Re: 91mm piston
Post by: kaw rider on April 20, 2008, 04:18:47 PM

BDI
that would be easy to do. i would charge $250.00 to do that. that includes welding, but not replate.

Title: Re: 91mm piston
Post by: kaw rider on April 20, 2008, 08:56:57 PM

i hope i don't get in trouble for posting this picture.

Title: Re: 91mm piston
Post by: kaw rider on April 21, 2008, 06:08:42 AM

because this charger is the r&d stages. there making this for powersports industy.