KX Riders

Maintenance & Technical => KX500 Original => Topic started by: Bcsnowbiker on May 16, 2019, 06:55:30 AM

Title: Flywheel clearance question
Post by: Bcsnowbiker on May 16, 2019, 06:55:30 AM

Does the flywheel have enough clearance to run hex head bolts like in the bottom left corner or do I need to run the OEM Phillips like the top right bolt and deal with this on dissasemby?
It wasn't the worst easy out I've delt with but the Phillips was already stripped by previous owner.

Title: Re: Flywheel clearance question
Post by: Bcsnowbiker on May 16, 2019, 07:01:08 AM

Wrong picture

Title: Re: Flywheel clearance question
Post by: 1901306708 on May 17, 2019, 01:48:15 PM

I use an 8mm hex on mine and nothing rubs. I have a pvl ignition though

Title: Re: Flywheel clearance question
Post by: Bcsnowbiker on May 17, 2019, 04:24:44 PM

Thanks
I will have to look more into the pvl ignition....

Title: Re: Flywheel clearance question
Post by: 1901306708 on May 19, 2019, 07:33:01 AM

its ok. nothing to get too excited about. don't get it wet, which is hard to do on a snowbike.

Title: Re: Flywheel clearance question
Post by: Bcsnowbiker on May 20, 2019, 01:26:58 PM

I have to dry my ignition after every ride from condensation